Subject:

Message (max 5k):
 
Insert picture using [img] http://yourdomain/yourpicture.jpg [/img] (max.width 640 pixels)
Insert hyperlink using [url] http://yourdomain/yourfilename.htm [/url]
 
---Previous message:--- : I'm almost shure that you just need to reset the throttle response : : "Throttle unit initialisation : Initialisation is necessary in the following cases: : 1. If the ECU is changed : 2. If the throttle unit is changed : Procedure: : Note: : The engine must not be started during the procedure, if it is, the procedure is void. : This procedure cannot function if the throttle unit is disconnected or its harness is cut. : 1. Turn on the ignition and disconnect the throttle unit : 2. Wait for at least 5 seconds : 3. Turn off the ignition : 4. Reconnect the throttle unit : 5. Turn the ignition on again. : 6. Fully open the throttle (accelerator cable properly adjusted) and return to the idle position (throttle : full travel is learned by the ECU) : 7. Turn off the ignition : 8. Clear the fault codes" : : You don't have to clear the error codes now. : I'll place a short guide on the forum shortly

or show a preview