Re: elystar 50ccm TSDI - no answer for the throttle cange
---Previous message:---
: Hi,
Hi Laszlo. Welcome!
: Is there any way to RESET the ECU???? Or any idea?
Perhaps you should try to reset the throttle unit.
From elsewhere on this forum, I found:
"Throttle unit initialisation
Initialisation is necessary in the following cases:
1. If the ECU is changed
2. If the throttle unit is changed
Procedure:
Note:
The engine must not be started during the procedure, if it is, the procedure is void.
This procedure cannot function if the throttle unit is disconnected or its harness is cut.
1. Turn on the ignition and disconnect the throttle unit
2. Wait for at least 5 seconds
3. Turn off the ignition
4. Reconnect the throttle unit
5. Turn the ignition on again.
6. Fully open the throttle (accelerator cable properly adjusted) and return to the idle position (throttle
full travel is learned by the ECU)
7. Turn off the ignition
8. Clear the fault codes"
I wish you the best of luck.
posted by Erick at 10 Nov 2008 19:49
Message overview
Post a reply to this message
|
|
|
